MAGTEK MCP DRIVER DOWNLOAD

Page 45 Section 5. Disabling this property will greatly reduce the development effort required to implement the MCP protocol. This command is used to power down a smart card in the currently selected connector. IntelliStripe Command Reference When the eject type is set to blind 2 , the reader will attempt to eject the card without using any sensors. This property gives a detailed analysis of the ATR as received from the card.

Uploader:	Momuro
Date Added:	17 September 2015
File Size:	51.88 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	76755
Price:	Free* [*Free Regsitration Required]

This property is used to control the magnetic stripe read direction. This application deals with the host controlled LED.

Data Field from card SW1 SW2 Data indicates the protection status for the byte located at the corresponding address on the card.

However, this format is obsolete.

If this property is set to true then cards encoded to JIS X type 2 standards can be decoded. IntelliStripe Command Reference When the eject type is set to blind 2the reader will attempt to eject the card without using any sensors. Single card slot design simplifies user interface and removes ncp human-error element ensuring quality magstripe and smart card encoding.

Typical intellicat installation version | MagTek IntelliCAT User Manual | Page 4 / 5

The Data consists of a 1-byte command Number Op Code and optional data bytes. Parity Error in received data. IntelliStripe Command Reference Of course the operation requested may complete without encountering any abnormal situations at all. This property specifies an audible tone that may be played when the host chooses.

Criteria for treating abnormal situations may change from application to application. The reader can only read during card ejection.

Page 89 Section 9. Page 63 Section 7.

Memory Card Support The bit address is added to the byte address to form the address of the first bit to be affected by the command. The reader will not attempt to consume a card if a card is already magteek in the transport.

Accessories, Related documents – MagTek SWIPE & PARK User Manual

The transport application must be used to acquire magnetic stripe data before any data is available to decode and present by the magnetic stripe application. Use the property number of the desired tone sequence.

This application works closely with the Magnetic Stripe application. Page 27 Section 4.

If the action completes in a timely manner, a Response message is magtrk informing the Host Application of completion. None Response Message Data: Not all device applications support these commands. Or point us to the URL where the manual is located. These commands are used to retrieve and set the value of magtej properties. Op Code one byte AD Name: This device will send all responses within 5 seconds.

If the notify read state is not set to OFF, then a notification message will be sent to the host when a card is read. Op Code one byte AC Name: Memory Card Support Address 72………. This will put the device in its power up state.

Software accessories, Related documents – MagTek IntelliStripe 350 User Manual

This application deals with device functionality. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of Maftek, Inc.

A Clear Data command is issued. The reader can only read during card consuming.